SPP Allows normal speed operation but in one direction only. Your system configuration amount of memory, add-in cards, peripherals, etc. Enter the directory and filename under which you would like the DMI file saved. Green Switch This switch will allow your system to enter the Suspend mode. To ensure that adequate power is provided, use a Watt or greater power supply. Use a diskette that is not write-protected.

Uploader: Kazishicage
Date Added: 9 September 2016
File Size: 43.14 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 86236
Price: Free* [*Free Regsitration Required]

DFI AZTC User Manual – My Slim Fix

Some entries are defaults required by the system board, while others, if enabled, will improve the performance of your system or let you set some features according to your preference. If a mouse is not connected to this port, the system will reserve IRQ12 for other expansion cards.

Make sure the correct drive type for the hard disk drive has been entered in the BIOS.

Remove the jumper caps from pins az30-tc/tll pins of J8 prior to connecting the audio cable connector. If you are using the COM 2 serial port, make sure this field is set to Normal. Includes high resolution monochrome adapters.

The parameters will auto- matically be shown on the screen. All, But Diskette The system boot will not stop for a disk error; it will stop for all other errors.


The default setting is All Errors.


The CPU will fit in only one orientation and can easily be inserted without exerting any force. Chapter 2 – Hardware Installation 2.

Usually the size is slightly greater than the size of a formatted disk given by a disk checking program. Once the CPU is in place, push down the lever to lock the socket. Shutdown Temperature You can prevent the system from overheating by selecting a temperature in this field. Use a diskette that is not write-protected. The time is based on the hour military-time clock.

Handle the CPU by its edges and avoid touching the pins. Page 19 Hardware Installation 5. The operating session will resume exactly where you left off the next time you power-on the system.

By default, the system boots up with NumLock zz30-tc/tl wherein the function of the numeric keypad is the number keys. Blank Screen This only writes blanks to the video buffer.

DFI AZ30-TC User Manual

Retaining clip Tab 3. If the add-in card is loose, power off the system, re-install the card and power up the system. Gold mark Pin 1 6. Set JP3 pins 2 and 3 to On.

Swap Floppy Drive When this field is enabled and the system az30-tct/l booting from the floppy drive, the system will boot from drive B instead of drive A. Package Checklist Introduction tions and operating system. This port works well with any application that is compatible with the standard PC joystick. The value of the base memory is typically K for systems with K memory installed on the motherboard or K for systems with K or more memor y installed on the motherboard.


DFI AZ30-TL – motherboard – micro ATX – Socket A – KM266

Page 95 Supported Software 4. You should use these values only if you have hardware problems. Make sure the az30-ct/tl stripe on the ribbon cable is aligned with pin 1 of connector J7. Make sure the keyboard is properly connected. The screen is off when the system is in the Suspend mode.

This indicates the switch is set to a different setting B System Error Message than indicated in Setup. These settings are not optimal and dfo off all high performance features. If the system is configured with two hard drives, make sure the bootable first hard drive is configured as Master and the second hard drive is configured as Slave.